Provision The Hub/Spoke; Figure L-4. Rpr Line Module Provisioning Menu - ADTRAN Total Access 5000 Deployment Manual

Total Access 5000 Business Services Deployment Guide
2. From the Provisioning menu, select Card Service State , and press E
3. From the Card Service State menu, select the appropriate service state, and press E

Provision the Hub/Spoke

Rings originating at a COT Node require no provisioning.
NOTE
• If an RPR ring originates at a Remote Terminal, then the Hub/Spoke Mode
must be set to Hub on the originating Node.
• The COT Node automatically sets to Hub Mode.
To provision the Hub/Spoke, complete the following:
1. From the RPR Line Module menu, select Provisioning , and press E
2. From the Provisioning menu, select Hub/Spoke Mode , and press E
3. From the Hub/Spoke menu, select the required option, and press E
L-6
TID: HSV00001
Unacknowledged Alarms: None
1. Card Service State
2. Redundancy
3. RPR Provisioning
4. Allow Any SFP
5. Timing
6. Software Update
7. Restore Factory Defaults
8. Multicast VLAN
9. Hub/Spoke Mode

Figure L-4. RPR Line Module Provisioning Menu

Total Access 5000 System
RPR LM Provisioning
: In Service
: no
: Loop A
: Disabled
: Hub/Spoke
Selection :
'?' - System Help Screen
MM/DD/YY HH:MM
Unit Number: 1
/ Loop B
NTER .
NTER
.
NTER
NTER .
NTER .
65K510DEP08-1A
.