Disable Unused NetVanta 838 Interfaces
The NetVanta 838 declares alarms for all unused interfaces (SHDSL, EFM, Ethernet, and
Power Feed). To clear these alarms once the 838 is turned up, the appropriate interfaces must
be shut down.
This subsection details the following information
• Disable the SHDSL interfaces
• Disable the Ethernet interfaces
• Disable the Gigabit‐Ethernet interface
• Disable the power feed alarms
• Clear the alarm log
Disable the SHDSL Interfaces
For each unused SHDSL port in the EFM Bonding Group, complete the following procedure:
NOTE
This must be done to clear the SHDSL loss of signal and EFM near end sync
alarms.
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, access the unused SHDSL portʹs configuration
3. From the SHDSL Interface Configuration prompt, shut the SHDSL port down by typing
4. Repeat steps 2 to 3 for the remaining unused SHDSL ports.
5. From the SHDSL Interface Configuration prompt, type exit , and press E
6. From the Global Configuration prompt, type interface efm-group 1/0/1 , and press
7. Remove the SHDSL port from the bonding group by typing no link <slot/port> ,
8. Repeat step 7 to remove all unused ports from the EFM bonding group.
9. Type end , and press E
Once all unused SHDSL interfaces have been disabled, all SHDSL and EFM bonding group
alarms should be cleared in the alarm log, and the EFM LED should be lit solid green, if there
are no other issues. Also, the partial EFM group alarm should clear.
65K510DEP08-1A
bal Configuration prompt.
prompt by typing interface shdsl 1/0/<port> , and press E
, and press E
shutdown
NTER
the Global Configuration prompt.
E
to access the EFM Bonding Group Configuration prompt.
NTER
and press E
. For NetVanta products, the slot is always zero.
NTER
NTER
Section 4, EoCu Provisioning - Disable Unused NetVanta 838 Interfaces
.
to return to the Enable prompt.
NTER
to access the Glo‐
NTER
.
NTER
to return to
4-31