NOTE
If connected to the shelf where the module resides, the shelf number is
typically 1.
2. From the Global Configuration prompt, provision the module administration state by
3. From the Global Configuration prompt, type interface shdsl <shelf/slot/port> ,
4. To configure the Circuit ID, type description LINE , and press E
5. Provision the SHDSL port administration state by performing one of the following
6. To set the alarm thresholds, type thresholds [cvc|es|losws|ses|uas] [15
Table 4‐3 provides the syntax and alarm threshold definitions for arg_1 and arg_2.
Syntax
arg_1
arg_2
7. Repeat steps 3‐8 for each SHDSL port that needs to be provisioned.
8. Type end , and press E
65K510DEP08-1A
performing one of the following commands:
• Type no slot shutdown <shelf/slot> , and press E
• Type slot shutdown maintenance <shelf/slot> , and press E
slot Out of Service Maintenance
• Type slot shutdown <shelf/slot> , and press E
Service, Unassigned
and press E
NTER
.
commands:
• Type no shutdown , and press E
• Type shutdown maintenance , and press E
Maintenance
• Type shutdown , and press E
minute|24 hour] <0-2147483647>
Table 4-3. 32-Port SHDSL EFM Alarm Thresholds
NTER
Section 4, EoCu Provisioning - Provision the 32-Port SHDSL EFM
NTER
to take the port In Service
NTER
to take the port Out of Service, Unassigned
, and press E
Definition
Select the threshold to configure the following:
• cvc ‐ Code Violation Count
• es ‐ Errored Seconds
• losws ‐ Loss of Sync Word Seconds
• ses ‐ Severely Errored Seconds
• uas ‐ Unavailable Seconds
Enter the second alarm threshold to one of the following:
• 15‐minute ‐ This reports any violations within a 15‐minute time
frame. Valid values are 0‐2147483647.
• 24‐hour ‐ This reports any violations within a 24‐hour time frame.
Valid values are 0‐2147483647.
to return to the Enable prompt.
NTER
to take the slot In Service
NTER
to take the slot Out of
NTER
.
NTER
NTER
to take the port Out of Service,
NTER
.
to take the
4-5