Provisioning Steps
This process establishes a connection between the physical port and the virtual network.
To create the EVC, complete the following procedure:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type evc <evc_name> , and press E
3. From the EVC Interface Configuration prompt, type s-tag <1-4094> , and press E
4. From the EVC Interface Configuration prompt, type connect men-port default
NOTE
The connect men‐port gigabit‐ethernet command entry applies to the active
GigE SM, independent of which GigE SM is actually specified, in an Active/
Standby configuration.
5. From the EVC Interface Configuration prompt, type connect men-port gigabit-
6. From the EVC Interface Configuration prompt, type no shutdown and press E
7. From the EVC Interface Configuration prompt, type end and press E
ELAN Definition
An Emulated Local Area Network (ELAN) is a single shelf application that supports single
tagged MEPs for Ethernet OAM. Double tagged MEPs for Ethernet OAM when doing ELAN
are not supported. An ELAN EVC can be provisioned with endpoints accessed from any EoF
access module. Mixed access ELAN EVCs are also possible.
Provisioning Steps
To provision an ELAN, complete the following:
1. From the Enable prompt, type config term , and press E
2. From the Global Configuration prompt, type evc WORD , and press E
3. From the EVC Interface Configuration prompt, type connect men-port gigabit-
4. From the EVC Interface Configuration prompt, type mac-switched , and press E
5. From the EVC Interface Configuration prompt, type end and press E
65K510DEP08-1A
bal Configuration prompt.
to set the S‐tag of the EVC.
ethernet interface 1/A/1
to the EVC.
ethernet <shelf/slot/group>
enable the EVC.
Enable prompt.
ethernet <shelf/slot/port>
Use this command to configure which GigE 8‐Port LM port the selected EVC is applied
to.
enable MAC Switching.
Enable prompt.
Section 7, EoF Provisioning - Create an EVC Cross Connect
, and press E
NTER
to connect the active SM Net 1 interface
, and press E
NTER
to connect the GE 8‐Port to the EVC.
, and press E
NTER
.
NTER
to get to the Glo‐
NTER
.
NTER
to return to the
NTER
NTER
.
NTER
.
NTER
NTER
to return to the
NTER
to
to
7-7