Total Access 5000 Business Services Deployment Guide
Disable Unused NetVanta 800 Interfaces
The NetVanta 800 declares alarms for all unused interfaces (DS3, EFM, Ethernet, and Power
Feed). To clear these alarms once the 800 is turned up, the appropriate interfaces must be shut
down.
This section details the following information
• Disable the DS3 interfaces
• Disable the Ethernet interfaces
• Disable the Gigabit‐Ethernet interface
• Disable the power feed alarms
• Clear the alarm log
Disable the DS1 Interfaces
For each unused DS1 port in the EFM Bonding Group, complete the following:
NOTE
This must be done to clear the DS1 loss of signal and EFM near end sync
alarms.
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, access the unused DS3 portʹs configuration
3. From the T3 Interface Configuration prompt, shut the DS3 port down by typing
4. Repeat steps 2 to 3 for the remaining unused DS3 ports.
5. From the T3 Interface Configuration prompt, type exit , and press E
6. From the Global Configuration prompt, type interface efm-group 1/0/1 , and press
7. Remove the DS3 port from the bonding group by typing no link <slot/port> , and
8. Repeat step 7 to remove all unused ports from the EFM bonding group.
9. Type end , and press E
Once all unused DS3 interfaces have been disabled, all DS3 and EFM bonding group alarms
should be cleared in the alarm log, and the EFM LED should be lit solid green, if there are no
other issues. Also, the partial EFM group alarm should clear.
6-28
bal Configuration prompt.
prompt by typing interface t3 1/0/<port> , and press E
, and press E
shutdown
NTER
Global Configuration prompt.
E
to access the EFM Bonding Group Configuration prompt.
NTER
press E
. For NetVanta products, the slot is always zero.
NTER
NTER
.
to return to the Enable prompt.
NTER
to access the Glo‐
NTER
.
NTER
to return to the
65K510DEP08-1A