Total Access 5000 Business Services Deployment Guide
4. From the EVC‐Map Configuration prompt, enable the map by typing no shutdown , and
5. Type exit and press E
6. Type exit and press E
7. To save the changes to non‐volatile memory, type write , and press E
8. From the Enable prompt, view the new map by typing show evc-map WORD , and press
Map Example
The following is a sample output of the show interfaces map command for map‐2010.
4-26
f. L2CP: This configures the map to pass only layer 2 control protocol traffic. To
enable, type match l2cp . To remove this from the match criteria, type no match
l2cp
.
press E
NTER
.
NTER
NTER
E
NTER
.
This command also displays the EVC and UNI that the map is attached to.
Once this process is completed, data can be run through the system.
MyNV838#show evc-map my_test_map
Admin State
EVC-map Status
Connected EVC
Policer
Connected UNI
Match Traffic Type
Match Traffic Type
MyNV838#
to return to the Global Configuration prompt.
to return to the Enable prompt.
: Enabled
: Running - Enabled
: evc2010
: None
: Ethernet 1/0/1
: Broadcast
: Multicast
.
NTER
65K510DEP08-1A