7. From the System‐Timing Configuration prompt, type source primary external
8. From the System‐Timing Configuration prompt, type exit , and press E
9. If necessary, repeat steps 3 ‐ 6, replacing primary with secondary, for a secondary
System Timing Configuration for Remote Terminal Node
To configure the system timing for the Remote Terminal Node, complete the following:
1. Log on to the Remote Terminal Node.
2. From the Enable prompt, type configure terminal , and press E
3. From the Global Configuration prompt, type system-timing 1 , and press E
4. From the System‐Timing Configuration prompt, type source primary interface
5. From the System‐Timing Configuration prompt, type source secondary interface
6. From the System‐Timing Configuration prompt, type revertive hop-count , and
7. From the System‐Timing Configuration prompt, type exit , and press E
65K510DEP08-1A
, and press E
primary
NTER
external source.
Global Configuration prompt.
ten-gigabit-ethernet 1/A/2 fixed
ten-gigabit-ethernet 1/B/2 fixed
press E
NTER
.
Appendix N, ERPS Provisioning - ERPS Configuration
.
, and press E
, and press E
NTER
.
NTER
to access the
NTER
NTER
.
NTER
.
NTER
.
.
N-5