Ring Interface Creation
To configure the ring interface, complete the following:
1. After establishing a connection with the SCM, pressing any key displays the Total Access
NOTE
The account name and password fields are case‐sensitive.
The default account name is "ADMIN" and the password is "PASSWORD."
Other default accounts are: READONLY, READWRITE, and TEST. An
account with ADMIN privileges is required to change the account name and
password.
2. Type the default account name, ADMIN (or the configured account name with System
3. Type the default password, PASSWORD (or the configured password), and press E
4. The Total Access 5000 Main Menu is displayed.
5. From the Main Menu, select System CLI and press E
6. On the CLI menu, verify that the Telnet Port is 2008. This is the default telnet designation.
7. From the CLI menu, select CLI Command Entry and press E
8. The following response is displayed: Use EXIT to exit CLI session .
9. Select "Y" to enter the CLI command interface.
10. Type enable , and press E
11. From the Enable prompt, type configure terminal , and press E
12. From the Global Configuration prompt, type interface erps 1/A/1 , and press E
NOTE
If SM‐B is active on the Node, the command changes to interface erps 1/B/1.
13. From the ERPS Interface Configuration prompt, type west interface
14. From the ERPS Interface Configuration prompt, type east interface
15. From the ERPS Interface Configuration prompt, type no shut , and press E
16. From the ERPS Interface Configuration prompt, type exit , and press E
17. From the Global Configuration prompt, type ethernet default interface erps 1/
65K510DEP08-1A
5000 System logon screen.
Administrator privileges), and press E
If this is not displayed, select CLI Telnet Port option and set the port to 2008. Press the E
key to return to the CLI menu.
Global Configuration prompt.
ten-gigabit-ethernet 1/A/2
ten-gigabit-ethernet 1/B/2
port In Service.
, and press E
B/1
NTER
.
Appendix N, ERPS Provisioning - ERPS Configuration
NTER
.
NTER
to enable privileged commands.
, and press E
NTER
, and press E
NTER
NTER
.
.
NTER
to access the
NTER
.
.
NTER
.
NTER
SC
.
NTER
NTER
to set the
.
N-3