Total Access 5000 Business Services Deployment Guide
8. Create a map at the NetVanta 838 that informs the unit to switch data from a given User
9. Provision policers in the NetVanta 800.
10. For more information, refer to "Provision Policers in the NetVanta 838" on page 4‐27.
11. Provision MAC Address Limiting and Aging.
12. Disable any unused interfaces.
Provision the 32-Port SHDSL EFM
This subsection details provisioning the 32‐Port SHDSL EFM service state.
Provision the 32-Port SHDSL EFM Administration Status
The 32‐Port SHDSL EFM card service state must be set to In Service or Out of Service, Mainte‐
nance.
NOTE
If the card service state is set to Out of Service, Maintenance, normal
operation occurs but alarms are not reported.
For traffic to pass, the 32‐Port SHDSL EFM module must be enabled.
Table 4‐2 displays the three administration states and shows the equivalent Service State from
prior releases.
Command
no shutdown
shutdown maintenance
shutdown
To set the module administration and port administration states, complete the following
procedure:
1. From the Enable prompt, type configure terminal , and press E
4-4
to Network Interface (UNI), at a minimum, to a particular EVC, and vice versa.
For more information, refer to "Create an EVC Map" on page 4‐24.
For for more information, refer to "Provision MAC Address Limiting and Aging" on
page 4‐30.
For more information, refer to "Disable Unused NetVanta 838 Interfaces" on page 4‐31.
Table 4-2. 32-Port SHDSL EFM Administration States
bal Configuration prompt.
Previous
Description
In Service
In the
and alarms are generated.
Out of Service,
In the
Maintenance
fic passes but no alarms are generated.
Out of Service,
In the
Unassigned
and no alarms are generated.
no shutdown
state, traffic passes
shutdown maintenance
state, traf‐
shutdown
state, no traffic passes
to access the Glo‐
NTER
65K510DEP08-1A