Add a Link to the PPP Group
To add a link to the PPP group, complete the following steps:
1. From the Enable prompt, type show interfaces ppp-group , and press E
NOTE
As an alternative, type show ppp-group <shelf> or show ppp-group
<shelf/slot>
the slot.
2. From the Enable prompt, type configure terminal , and press E
3. From the Global Configuration prompt, type interface ppp-group <shelf/slot/
4. If adding a second link, Multilink PPP must be enabled. From the PPP Group Interface
5. From the PPP Group Interface Configuration prompt, type one of the following
Delete a Link from the PPP Group
To remove a link from the PPP group, complete the following steps:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type interface ppp-group <shelf/slot/
3. From the PPP Group Interface Configuration prompt, type one of the following
65K510DEP08-1A
all PPP groups in the Total Access 5000.
to see an abbreviated list of ppp‐groups/links on the shelf or
Global Configuration prompt.
, and press E
group>
NTER
Configuration prompt, type ppp multilink , and press E
commands:
• To provision the CH DS3 PPP/MLPPP 3‐Port Line Module, type link <slot/
, and press E
port:channel>
• To provision the DS1 PPP/MLPPP 32‐Port Line Module, type link <slot/port> ,
and press E
NTER
to add a link to the group
bal Configuration prompt.
, and press E
group>
NTER
commands:
• To provision the CH DS3 PPP/MLPPP 3‐Port Line Module, type no link <slot/
, and press E
port:channel>
• To provision the DS1 PPP/MLPPP 32‐Port Line Module, type no link <slot/
, and press E
port>
Section 5, BSM Provisioning - Create a Point-To-Point Protocol Group
to access PPP Group Interface Configuration prompt.
NTER
to add a link to the group
to access PPP Group Interface Configuration prompt.
NTER
to remove a link to the group
NTER
to remove a link to the group
NTER
to view
NTER
to access the
NTER
.
NTER
to access the Glo‐
5-11