Verify Bonding Group Creation; Table 6-3. Efm Bonding Group Variables - ADTRAN Total Access 5000 Deployment Manual

Syntax
WORD
EFM links
active‐links‐minimum
upstream/downstream
4. From the EFM Configuration prompt, type exit , and press E

Verify Bonding Group Creation

To verify that the bonding group was created, and determine the slot and group ID assigned
to the group, perform one of the following:
• From the Enable prompt, type show interfaces efm-group , and press E
• From the Enable prompt, type show table interfaces efm-group , and press E
• From the Enable prompt, type show efm-group 1 , and press E
65K510DEP08-1A
Table 6‐3 displays the list of variables for the EFM bonding group.

Table 6-3. EFM Bonding Group Variables

Description
Enter the name (up to 50 alphanumeric characters with no spaces or spe‐
cial characters) of the bonding group.
Enter the EFM links to add to the bonding group. Each link must be in the
slot/port:channel format.
Enter the number of links in the group required to provide the upstream
and downstream rates. Any additional links will be hot standby links.
The values after the upstream and downstream keywords are the
upstream and downstream rates for the bonding group.
Application Configuration prompt.
all EFM bonding groups in the Total Access 5000
to view a table (with limited EFM group information)
assigned to all groups in the shelf along with the provisioned group rates
Section 6, EoTDM Provisioning - Create an EFM Bonding Group
NTER to return to the
to view
NTER
NTER
NTER to see the links
6-7