Total Access 5000 Business Services Deployment Guide
Provision the EFM Bonding Protection Module
Administration State
For traffic to be protected in the event of an EFM bonding engine failure, the EFM Bonding
Protection Module card service state must be set to IS or OOS‐MA. The default service state
for the 32‐Port SHDSL EFM EFM is OOS‐MA.
NOTE
If the card service state is set to OOS‐MA, normal operation occurs but alarms
are not reported.
To set the card service state, complete the following procedure:
Table 4‐4 displays the three administration states.
Command
no shutdown
shutdown maintenance
shutdown
To set the card service state, complete the following procedure:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, provision the administration state by
NOTE
• If connected to the shelf where the module resides, the shelf number is
typically 1.
• This is the slot of the module being configured. Valid values are
1
3. Type end , and press Enter to return to the Enable prompt.
4-6
Table 4-4. EFM Bonding Protection Module Administration States
bal Configuration prompt.
performing one of the following commands:
• Type no slot shutdown <shelf/slot> , and press E
– 11 and 13 – 22 .
• Type slot shutdown maintenance <shelf/slot> , and press E
slot Out of Service, Maintenance
• Type slot shutdown <shelf/slot> , and press E
Service, Unassigned
Previous
Description
In Service
In the
and alarms are generated.This is the
default value.
Out of Service,
In the
Maintenance
traffic passes but no alarms are generated.
Out of Service,
In the
Unassigned
and no alarms are generated.
no shutdown
state, traffic passes
shutdown maintenance
shutdown
state, no traffic passes
NTER
to access the Glo‐
NTER
to take the slot In Service
to take the
NTER
to take the slot Out of
NTER
65K510DEP08-1A
state,