6. From the EVC Interface Configuration prompt, type no shutdown , and press E
7. From the EVC Interface Configuration prompt, type end , and press E
Redirect EVCs
When a link aggregation is created and enabled, any service EVCs previously connected to the
Gigabit‐Ethernet port must be redirected to the newly created link aggregation group.
NOTICE
If not redirected to the Gigabit‐Ethernet port, the EVCs will be left hanging.
To redirect the EVCs to a link aggregation group, complete the following procedure:
1. From the root prompt, type show evc , and press E
2. From the Enable prompt, type configure terminal , and press E
3. From the Global Configuration prompt, type evc <shelf/slot/index> , and press
4. From the EVC Interface Configuration prompt, type no connect men-port
5. From the EVC Interface Configuration prompt, type connect men-port lag-group
6. Type exit , and press E
7. Repeat steps 3‐6 as necessary.
65K510DEP08-1A
enable the EVC.
Enable prompt.
Access 5000.
For any EVCs that are connected to the Gigabit‐Ethernet port, perform the following
steps to disconnect them from the GE port and connect them to the LAG group.
Global Configuration prompt.
E
NTER
to access the EVC Interface Configuration prompt.
gigabit-ethernet 1/a/1
, and press E
1/C/1
NTER
to connect the EVC to the newly created LAG group.
NTER
Appendix A, Link Aggregation Guide - Link Aggregation Provisioning
, and press E
NTER
to disconnect the EVC from the GE port.
to return to the Global Configuration prompt.
NTER
to return to the
NTER
to display all EVCs in the Total
NTER
to access the
NTER
to
A-5