Table of Contents
Advertisement
Unit Installation
Getting Started
The 10/100BaseT Ethernet interface MUST NOT be metallically connected to interfaces
which connect to the Outside Plant or its wiring. This interface is designed for use as an
intrabuilding interface only. The addition of primary protectors is not sufficient protection
to connect this interface metallically to OSP wiring.
Connect to the NetVanta 300 Series Unit
1. Connect the NetVanta 300 Series unit to the PC using one of the
the unit and the appropriate Ethernet cable.
2. Supply power to the PC and the NetVanta 300 Series unit and begin the operating system boot up
process. During boot up, the PC will obtain an IP address from the NetVanta 300 Series unit
DHCP server. By default, both the DHCP and HTTP servers are enabled. The default IP address is
10.10.10.1.
3. Enter the unit's IP address in your browser address line. The default IP address is
4. You will then be prompted for the username and password (the default settings are
).
password
5. The initial GUI screen appears.
6. Click on
Getting Started
on-line instructions.
For security purposes, you should set up an admin password immediately. Use the
Passwords page of the Web GUI to change this password.
By default, the NetVanta 300 Series unit comes with an ADSL and an ATM port already
configured and enabled. The service provider should provide a PVC (VPI / VCI) number
which will be used to configure the ATM PVC.
Configure the ATM PVC
1. Click on the
Getting Started
2. Click on
Step 1 - Configure the Public Interface
page.
PVC
3. Fill in the PVC number and select an
is chosen, you will need to enter an IP address.
IP Routing
4. Click
. If PPP or PPPoE is selected as the
Apply
page after clicking
authentication passwords, and the
to be
Negotiated
26
in the
System
link under the
Interface Mode
. Here you will need to select the type of authentication needed,
Apply
Address Type
. Click
when all the information is complete.
Apply
Copyright © 2006 ADTRAN, Inc.
NetVanta 300 Series Hardware Installation Guide
menu on the left side of your screen and follow the
menu. This will bring up a side bar page.
System
at the top of the side bar page to open the
. This is usually PPP or PPPoE; however, if
Interface Mode
. In most cases you will want the
ETHERNET
ports on the back of
10.10.10.1
admin
, you will be taken to the
Address Type
61200422L1-34D
.
and
ATM
PPP
Advertisement
Table of Contents
