T1 Alarm Severity Level; Table H-3. T3 Parameter Values; Table H-4. T1 Parameter Values - ADTRAN Total Access 5000 Deployment Manual

T1 Alarm Severity Level

To set the alarm severity level for a T3 alarm, complete the following steps:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type interface t1 <shelf/slot/
3. From the T1 Configuration prompt, type alarm level <alarm_name>
Table H‐4 displays the T3 Parameter Values.
4. From the T1 Configuration prompt, provision the alarm status by performing one of the
5. From the T1 Configuration prompt, type end , and press E
65K510DEP08-1A
alarm_name
LOS
LOF
RAI
AIS
bal Configuration prompt.
, and press E
port:channel>
, and press E
<alarm_level>
valid alarm_name and alarm_level values.
alarm_name
LOF
RAI
AIS
following commands:
• Type no alarm enable <alarm_name> , and press E
alarm
• Type alarm enable <alarm_name> , and press E
prompt.
Appendix H, Alarm Severities - T1 Alarm Severity Level

Table H-3. T3 Parameter Values

alarm_level
Critical
Major
Minor
Alert
Information
NTER to access the T1 Configuration prompt.
to set the alarm severity level. Refer to Table H‐4 for
NTER

Table H-4. T1 Parameter Values

alarm_level
Critical
Major
Minor
Alert
Information
NTER to access the Glo‐
NTER to disable the specified
NTER to enable the specified alarm
to return to the Enable
NTER
H-3