4. To configure the Circuit ID, type description LINE , and press E
5. Provision the DS3 port administration state by performing one of the following
6. To set the alarm thresholds, type thresholds [cvc-p|cv-l|cvp-p|
7. Repeat steps 3‐8 for each DS3 port that needs to be provisioned.
8. Type end , and press E
65K510DEP08-1A
• To access the DS3 EFM 4‐Port, type interface t3 <shelf/slot/port> , and
press E
.
NTER
• To access the DS3 EFM 3‐Port, type interface t3 <shelf/slot/
port:channel>
, and press Enter.
commands:
• Type no shutdown , and press E
• Type shutdown maintenance , and press E
Maintenance
• Type shutdown , and press E
escp-p|es|esp-p|sefs-p|sescp-p|uas-p] [15 minute|24 hour]
, and press E
<0-4294967295>
NTER
Section 6, EoTDM Provisioning - Provision the Line Module
NTER
to take the port In Service
NTER
to take the port Out of Service, Unassigned
NTER
NTER
.
to return to the Enable prompt.
NTER
.
to take the port Out of Service,
6-5