Total Access 5000 Business Services Deployment Guide
Example #4
The steps to turn up a system with Net 1 as Uplink and Net 2 as Downlink are:
# configure terminal
(config)# node number 2
(config)# interface gigabit-ethernet 1/A/2
(config gig‐eth 1/A/2)# downlink
(config gig‐eth 1/A/2)# exit
(config)# exit
#
Provision the Gigabit-Ethernet Speed
To provision the Gigabit‐Ethernet speed, complete the following:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type interface gigabit-ethernet 1/A/1 ,
NOTE
If slot B is the active SM, use 1/B/1 for the <shelf/slot/port> syntax.
3. Provision the Gigabit‐Ethernet speed by performing one of the following commands:
NOTE
• The default Gigabit‐Ethernet speed is auto.
• The Auto Negotiation setting on the Total Access 5000 should be consistent
with the associated upstream switch port's Auto Negotiation setting.
• For more information on LACP, refer to "Appendix A, Link Aggregation
Guide".
4. Type end , and press E
3-10
bal Configuration prompt.
and press E
NTER
to access the GigE SM in slot A and the Net 1 Configuration prompt.
• Type speed 1000 , and press E
operation
• Type speed auto , and press E
NTER
NTER
to configure the gigabit ethernet for 1000 Mbps
NTER
to enable the auto‐negotiation of speed
to return to the Enable prompt.
NTER
to access the Glo‐
65K510DEP08-1A