Mount the Chassis
NOTE
When mounting the chassis, leave the mounting screws loose until the SMIO3
and fan module have been installed.
The chassis is shipped with two mounting brackets that are used to install the chassis with
either a 2‐inch, 3.3‐inch, 4.1‐inch or 5‐inch front projection. Each bracket is attached with five
screws, which are supplied with the chassis. Refer to Figure 2‐4 for mounting locations and
mounting bracket orientations.
65K510DEP08-1A
2-Inch Front
Projection
3.3-Inch Front
Projection
Figure 2-4. Mounting Bracket Locations
Section 2, Installation - Mount the Chassis
5-Inch Front
Projection
4.1-Inch Front
Projection
2-7