Table of Contents
Advertisement
Click the Service plus tab and select a service to be filtered. Tick the Remap check
box from the service row. Then, click Apply Changes. When the mouse hovers
over the Remap Config hyperlink, a list of the current components will be shown as
a pop up box (see above).
3.19.4.6.2
Component Configuration
To configure the components to be re-mapped, click on the Remap Config menu
item. The PID Remap sub-table will now be shown.
It is possible to filter and remap up to 30 components in addition to the PMT and the
PCR (if not embedded). When a configuration has been set for a selected service, it
will be stored and applied for any service selection. Therefore, if the service
changes, the components that best match the current configuration will be filtered
and remapped.
The following figure shows an example of a service configuration. To access this
table, click the Details hyperlink for the selected service to remap when in the
Service plus page.
Figure 3.174 Example of PID Remap Sub Table Showing a Component
•
•
•
•
EN/LZT 790 0005 R7A
Configuration
ES – Shows the component type icon.
Type – Shows the component type. '???' appears when the configuration
cannot match any present component.
PID – Input PID of the present component. '----' appears when the configuration
cannot match any present component.
Type cfg – Type of the configuration. This field must match the filtered
component type.
Using the Equipment
3-363
Advertisement
Table of Contents
