Table of Contents
Advertisement
3.10.5.10
Multicast Input Setup
Figure 3.51 IP Input Stream Setup
3.10.5.10.1
Listening Stream Section
•
•
•
•
•
•
•
•
•
•
•
•
•
EN/LZT 790 0005 R7A
FEC Enable – Enables the user to ENABLE/DISABLE Forward Error Correction.
This facility is only available when FEC is licensed.
Mcast IP 1/1 Address – Primary Multicast/Unicast address of listening IP TS. In
case of Unicast this address should be equal to local IP address.
Mcast IP 1/2 Address –Secondary Multicast/ address of listening IP TS. In case
of Unicast or no multicast redundancy this should be left as 000.000.000.000
Unicast Enable – Placing a check in the box enables the Unicast mode for the
primary stream on Port 1/2.
Source IP Address 1/1 – Enables the user to set the Primary multicast Source
IP Address for the primary stream on Port 1/2.
Source IP Address 1/2 – Enables the user to set the Secondary multicast
Source IP Address for the primary stream on Port 1/2.
UDP Port 1/1 – Listening UDP port for primary multicast.
UDP Port 1/2 – Listening UDP port for secondary multicast.
Column Port 1/1 – Colum port for primary multicast; by default it is "Listening
UDP port + 2", but can be reconfigured.
Column Port 1/2 – Colum port for secondary multicast; by default it is "Listening
UDP port + 2", but can be reconfigured.
Row Port 1/1 – Row port for primary multicast by default it is "Listening UDP
port + 4", but can be reconfigured.
Row Port 1/2 – Row port for secondary multicast by default it is "Listening UDP
port + 4", but can be reconfigured.
De-Jitter Buffer Level – IP de-jitter buffer level in milliseconds.
Using the Equipment
3-85
Advertisement
Table of Contents
