Table of Contents
Advertisement
Using the Equipment
3.18.4.6
Configuration
To configure the IP output card, select the Output tab from the top of the web page.
Figure 3.159 Output Tab > Filter Section
3.18.4.6.1
Filter
•
•
3-344
Service Filter Mode – Specifies the Service Filter Mode from a drop-down
menu. Options
are:
-
Off – The input transport stream is passed through without modification,
except where services may be descrambled.
Single Service – Only one selected service will be output (selection can be
-
made on Service plus tab).
-
Multi Service – A number of selected services will be present in the output
Transport Stream (selection can be made on Service plus tab).
-
Remap – The selected service will be present in the output Transport
Stream after PID remapping (selection and remapping can be made on
Service plus tab).
Bit rate Type – Enables selection of the bit rate type from a drop-down menu:
VBR – Variable Bit Rate: The output bit rate will be the sum of the service bit
-
rates. The bit rate depends on the encoding density of the source service.
-
CBR – Constant Bit Rate: The output Transport Stream will be extended
with NULL packets to ensure a constant output bit rate. The bit rate of the
useful packets are still variable.
EN/LZT 790 0005 R7A
Advertisement
Table of Contents
