Up/Down Conversion Parameters - Ericsson RX8000 Reference Manual

Table 3.20 Video Conversion Running on the 4:2:2 Decoder Option Card with the
Output Mode
AUTO
SD
720p
1080i
1080p
Key: * Down-conversion license required
3.13.4.6 Configuration
Down-conversion and up-conversion is controlled primarily through the use of the
Video Output Mode control. However, if the Video Output Mode is set to AUTO,
down-conversion is also be controlled using the SDI/ASI Output One, Output Two
and Output Three controls that can be set to SD-SDI, HD-SDI or AUTO (3G-SDI
and ASI are other possible options but not used for any conversion). Up-conversion
cannot be controlled using this AUTO option.
Supporting up to three SDI/ASI Output ports, these can be individually set to either
SD-SDI or HD-SDI to allow simultaneous screen formats from the RX8000 as
described above.
Where conversion licenses have not been enabled, some features may not be
available.
3.13.4.6.1

Up/Down Conversion Parameters

The RX8000 provides control over down-conversion, up-conversion and aspect ratio
conversion through the Decode > Advanced page.
Figure 3.102 Decode > Advanced Web Page
•
EN/LZT 790 0005 R7A
High Quality Down-conversion Card Fitted
4:2:2 Decoder + HQ Down Converter: Input Video
SD
SD
SD
-
-
-
Video Output Mode – This sets the main video output that gets routed to the
RX8000's SDI Output ports (not the composite output, this will always output SD
720p 1080i
720p 1080i
*
SD SD
720p 720p
- 1080i
- -
Using the Equipment
1080p
1080p
* *
SD
*
-
*
1080i
1080p
3-215