Its; Monochrome Samples - Ericsson RX8000 Reference Manual

•
3.17.1.6.11

ITS

Vertical Interval Test Signal (VITS) are a group of analog test signals inserted in the
composite video output. They allow performance measurements or receiver
corrections to be made.
Figure 3.139 Decode > VBI-VANC > ITS
•
•
3.17.1.6.12

Monochrome Samples

This provides the user with EN301 775 transparent mode data (4:2:2) samples,
known as monochrome sample data. This data is carried as PES data marked by
the descriptor tag 0x45.
Figure 3.140 Decode > VBI-VANC > Monochrome
•
•
•
EN/LZT 790 0005 R7A
- ENABLE – VIDEO AR – Enables insertion of WSS in to the video output
signal where the WSS data is sourced from the Aspect Ratio coded in the
video sequence header.
WSS-AFD Enable – Enabling this option allows the WSS waveform to carry the
AFD value when WSS Insertion is enabled.
ITS Status – Displays the ITS status inserted in to the VBI on the output.
ITS Line Generation – Enables or disables the insertion of VITS in to the video
output signal. The following options are available:
DISABLE
-
- ENABLE-(CCIR)
- ENABLE-(FCC/UK).
Monochrome Stream Status – Displays the presence of Monochrome data in
the incoming VBI PES stream.
Monochrome Output Status – Displays the presence of Monochrome data in
the VBI space of the output video.
Monochrome Insertion – Enables or disables insertion of Monochrome data in
to the VBI of the output signal.
Using the Equipment
3-291