Table of Contents
Advertisement
Using the Equipment
•
•
•
•
•
•
•
•
•
•
•
3.10.7.10
SNMP
The base SNMP node is 1.3.6.1.4.1.1773.1.3.208.2.8. MIBs can be downloaded
using the Save/Load tab of the web interface, section entitled Save MIBs file. The
card-specific MIBs are in the file named Rx8000 S15622 INPUT.mib in the
downloaded MIBs.zip.
3.10.7.11
Front Panel
The DVB-T2 controls on the front panel provide all of the status and control
information as described above it is recommended that the more advanced features
are controlled via the web interface, therefore only the basic tuning and status
parameters are provided here.
3.10.7.11.1
Input Alarm Status
This menu displays the current card alarm.
3-122
T2-frame num between two FEF parts – Indicates the number of T2-frames
between two FEF parts.
Number of PLPs – This feature is not supported and will always display 1.
PLP Id – The ID of the single PLP.
PLP Type – This defines the current PLP type. This can have the values:
Common (not supported), Data 1, Data 2.
PLP Payload – This defines the current PLP payload type. This can have the
values: TS, GFPS, GCS, GSE.
PLP Group Id – PLP group ID.
Max num of PLP blocks – Maximum num of PLP blocks available.
PLP Frame Interval – The distance in T2 frames between two frames which
contain this PLP.
PLP Time Interleaver length – This is the number of T2 frames to which each
Interleaving Frame is mapped.
PLP Time Interleaver type – This defines how many T2 frames are mapped to
interleaving frames. This can have the values:
-
0 if one interleaving frame is mapped to one T2 frame,
-
1 if one interleaving frame is mapped to many T2 frames.
-
--- otherwise.
In-band signalling in PLP – This indicates whether in-band signaling is present
at transmitting this PLP. The values can be: No or Yes.
EN/LZT 790 0005 R7A
Advertisement
Table of Contents
