Table of Contents
Advertisement
The NO SELECTION option allows the user to clear any PID selection and stop
processing. Depending on the state of the PMT Update Mode selected from the
Decode > Advanced > Selection Control section, this setting may be automatically
overridden by the RX8000 after a PMT update event.
Also provided is the option to select a USER PID that has been defined in the
Decoder > MPE section. This allows the user to process any MPE stream that has
not been declared in the PMT of the selected decode service.
3.17.6.6.2
Filter MAC
This selects the MAC address to be filtered within the section data, this MAC
address is also used as the destination MAC address within the re-assembled MAC
frame. This MAC address will have been configured by the IP Encapsulator at the
Head-End, the administrator of this Head-End must be contacted for the correct
MAC address. The downstream network equipment must also be setup to accept IP
datagrams with this destination MAC address.
Note: Setting the Filter MAC is mandatory to successfully use the MPE Data
3.17.6.6.3
User PID
The User PID field specifies the User PID value for MPE processing. The field
accepts PID values between 0 and 8191. The User PID is selected from the main
PID selection list.
3.17.6.6.4
MPE Enable
Placing a check mark in this box enables the Multi-Protocol Encapsulation
functionality.
3.17.6.6.5
MPE Packet In
This status field reports the number of MPE packets received from the incoming
Transport Stream based in the current PID selection.
3.17.6.6.6
MPE Packets Processed
EN/LZT 790 0005 R7A
functionality.
Using the Equipment
3-327
Advertisement
Table of Contents
