Installing the Equipment
2.3
Signal Connections
2.3.1
General
It is strongly recommended that the terminal marked
equipment is connected to a site Technical Earth before any external connections
are made and the equipment is powered. This limits the migration of stray charges.
All signal connections are made via the rear panel. A typical rear panel is shown in
Figure 2.2. Full technical specifications for the connections are given in Annex B.
The Receiver provides a flexible Transport Stream input interface. The status
information appropriate to each input type is available to the User via the User
Interface, and also via the remote control interfaces.
Figure 2.2 Rear Panels (RX8200, RX8252, RX8310, RX8315, RX8320 and RX8330)
2-4
Caution!
at the rear panel of the
EN/LZT 790 0005 R7A