Table of Contents
Advertisement
Using the Equipment
3.17.4.6.3
Status
The Status field reports back the current state of any Splice processing. Possible
status messages are:
•
•
•
•
•
Note: Where X seconds are specified, click Refresh to update this value.
3.17.4.6.4
Splice Event ID
This field displays the 32-bit hexadecimal value of the current event ID extracted
from the SCTE 35 message.
3.17.4.6.5
Unique Program ID
This field display the value extracted from the splice_insert command of the
SCTE 35 message. It provides a unique identification for viewing events within the
service.
3.17.4.6.6
Splice Count
3-318
IDLE – A network In Point has been processed and nothing else is pending. It
could also mean Splice processing is inactive, normally when no Splice PID is
selected or no Splice Event ID has been received / filtered.
NET OUT Pending (X seconds) – A network Out Point has been received but
not yet signalled by the RX8000, a time has been specified and the event is
pending (where X is the number of seconds remaining before signalling the
network Out Point). If the time specified failed to satisfy the minimum Pre-Roll
time and Clamp Pre-Roll is active, this will be indicated by adding the term
(Clamped) at the end of the Status field message.
NET OUT (Remaining duration X seconds) – A network Out Point has been
signaled by the RX8000, the duration has been specified (where X is the
number seconds) and the auto_return flag is set. A network In Point will be
signalled at the end of the duration period.
NET OUT (Expected duration X seconds) – A network Out Point has been
signaled by the RX8000 and the duration has been specified (where X is the
number seconds) but the auto_return flag was not set. A second splice_insert
message would be expected to signal a network In Point to end the break.
NET OUT (Duration indefinite) – A network Out Point has been signaled by the
RX8000 but no duration has been specified. A network In Point won't be
signaled until a further splice_insert message is received to indicate the event.
EN/LZT 790 0005 R7A
Advertisement
Table of Contents
