Table of Contents
Advertisement
Using the Equipment
This feature is only available with the Basic Audio Decoder devices. PTS
synchronization cannot be disabled on the Advanced Audio Decoder devices.
3.14.4.4.12
Audio Decoder > Cue Tone Detection
This field activates DTMF tone detection algorithms in the DSP.
This allows the receiver to monitor the audio service for DTMF tone sequences,
which can then be used to trigger SCTE 104 and / or SCTE 35 messages.
If enabled for any audio decoder and the receiver is setup for Multi Service Filtering
or Remapping, and the service is present in the output Transport Stream then the
decoded service will be modified to insert a SCTE 35 registration descriptor and a
reference to a SCTE 35 PID.
If disabled for all decoders, it will not modify the PMT in the output stream.
This feature is only available with the Advanced Audio Decoder devices and
therefore only the RX8200.
For further instructions / setup, see section 3.17.5 Cue Tone (DTMF) Splicing
Support.
3.14.4.5
Decode > Audio Output Routing > Audio Connectors
Figure 3.114 Decode > Audio Output Routing > Audio Connectors Window
Depending on the RX8000 variant and option cards fitted, a number of audio output
configurations are available. Where no cards are fitted to the RX8000, this menu
option may not be shown.
This refers to the physical audio output ports accessed at the rear of the RX8000:
Audio OUT 1, Audio OUT 2, Audio OUT 3 and Audio OUT 4. Each audio output port
has a DE9 interface that provides an analogue left channel, an analogue right
channel and a digital AES3 channel.
3.14.4.5.1
Audio Connectors > AUDIO OUT Source
3-250
EN/LZT 790 0005 R7A
Advertisement
Table of Contents
