Table of Contents
Advertisement
Using the Equipment
3.14.5.1
Audio
This menu provides sub-menus for viewing and editing audio component settings.
To access sub-menu for each of the audio decoders, press the (Forward) key.
3.14.5.1.1
Audio 1
This menu provides sub-menus for viewing and editing Audio Decoder 1 settings. To
access the sub-menus for the specific audio decoder, press the (Forward) key.
Use the (Down) key to navigate to the other audio decoders available.
3.14.5.1.1.1
Component Selection
This menu enables the viewing and editing of component selection for the
associated audio decoder.
After selecting the (Edit) key, use the (Up) and (Down) keys to toggle between
NO SELECTION, the Audio PID list and User PID options.
Each selection choice from the PID list details the PID value, the audio language
and the audio format. This information is derived from the audio descriptors listed in
the service PMT.
The NO SELECTION option is selected to stop the audio decoder. Depending on
the state of the PMT Update Mode, this setting may be automatically overridden by
the RX8000 after a PMT update event.
The User PID selection is selected if the desired audio stream is not present in the
audio PID list. User PID selections are not affected by the PMT Update Mode but
are dropped when a new decode service is selected.
Note: The same PID can be selected across the Advanced Audio Decoders;
3-254
SERVICE
4.7
AUDIO
4.7.1
AUDIO 1
4.7.1.1
however, this is not supported for the Basic Audio Decoders. If the same
PID is selected for both Basic Audio Decoders, one decoder will attempt to
decode and may report status RUNNING, but the second decoder will fail
and report status ERROR.
|AUDIO
|
|AUDIO 1
|
|COMPONENT SELECTION:
|256 – DUT AC-3
>
>
EN/LZT 790 0005 R7A
Advertisement
Table of Contents
