Redundancy; Input - Ericsson RX8000 Reference Manual

Using the Equipment
Figure 3.42 Input Web Page (IP Input Card fitted)
3.10.1

Input

•
•
•
•
•
•
3.10.2

Redundancy

•
3-60
Input Source – Enables a choice of Source Selection Mode from the drop-down
menu (options available depend on model and options fitted).
TS Lock – Displays the lock status of the Transport Stream input.
TS Bit rate – Displays the bit rate of the Transport Stream input (in Mbps).
Packet Length – Displays the packet length used in the Transport Stream.
ASI Status – Displays the lock status of the ASI input card (this is returned from
the ASI card rather than detected by the motherboard).
Option Card Input – Below the ASI Status field, the lock status of the input
option card is displayed. IP Input is shown in the figure above. This is the lock
status returned from the card and not the lock status detected by the
motherboard. Other input cards can be one of the following:
- SAT (DVB-S2, DVB-S2 ACM or DVB-S2X cards)
- 8VSB
- G.703
- IP Input
- Terrestrial (DVB-T/T2 card)
Input Source – Selects the source of the transport stream used for service
decode. When set to a specific input source, the redundancy mode is disabled
EN/LZT 790 0005 R7A