Cas-Id; Nds Pairing Key - Ericsson RX8000 Reference Manual

Integrated receivers/decoders
Hide thumbs Also See for RX8000:
Table of Contents

Advertisement

Using the Equipment
3.11.6.7
Front Panel
3.11.6.7.1
Alarms
This is a general text field which describes any alarms generated by the card. These
alarms are generated by fault conditions found by the NDS proprietary block of
code. These alarms are:
3.11.6.7.2

CAS-ID

This menu displays the currently detected CAS-ID (or CA System ID) supplied to the
unit by the CA system. The unit will use this ID to verify the CA type in the incoming
Transport Stream. If a match is found, it should be possible to descramble
components within the selected service.
3.11.6.7.3

NDS Pairing Key

This menu displays the NDS Pairing Key for the unit. Note that this Pairing Key is
actually assigned to the NDS card within the unit. If the card is changed then the
Pairing Key will also be changed.
This Pairing Key is used at the head end to uniquely identify the unit and to target
entitlements to it. As such when an upgrade to the units entitlements is requested
this number must be quoted.
3-166
TS Not Locked
Smartcard Removed
Invalid Smartcard
Smartcard Comms Failure
Invalid Image
Invalid Image In Flash
Number of Elementary Stream > 8
Invalid PID Configuration
Processor Overload
NDS Card Not Accessible
NDS
5.2.1
NDS
5.2.2
|ALARMS:
|SMARTCARD REMOVED
|CAS ID: 02401
|
EN/LZT 790 0005 R7A

Advertisement

Table of Contents
loading

Table of Contents