Table of Contents
Advertisement
•
•
•
•
•
•
•
•
•
•
3.18.4.6.4
Common
Figure 3.161 Output Tab > Common Cection
•
EN/LZT 790 0005 R7A
MAC Address – Displays the MAC address of the 1
Output Card.
Gateway – Enables input of the gateway address.
Src UDP Port – Enables input of the source User Datagram Protocol Port for
the Transport Stream packets sent from the 1
Card.
IP Dest – Enables input of the IP destination address, where the Transport
Stream packets will be sent to.
Dest UDP Port – Enables input of the destination User Datagram Protocol port.
QoS mode – Defines how to set the DSCP field of the IP header in the IP
packets, which defines the Quality of Service.
-
TOS – Type of service.
-
DSCP – Differentiated services Code Point.
QoS value – Sets the priority of the IP packets based on the QoS mode.
-
If QoS mode is TOS – Priority can be selected between 0 and 7.
-
If QoS mode is DSCP – The whole DSCP field can be set. The type of Per-
Hop Behavior and in addition the Class Pairs can be selected. There are four
types of Per-Hop Behaviors:
xxi.
Default PHB (default).
xxii. Class selector PHB (CSx) – Similar to TOS mode. Where x is Class
Pair.
xxiii. Expedited Forwarding (EFxx) – Where xx is Class Pair.
xxiv. Assured Forwarding (AFxx) – Where xx is Class Pair.
Time to Live – The TTL value of the IP packets can be defined.
Link Status – Display whether the link is up and the speed of the link.
Custom Src IP – Enables input of the custom source Internet Protocol address.
Link Speed – Enables the selection of the IP Output Card link configuration.
Using the Equipment
st
nd
/2
interface of the IP
st
nd
/2
interface of the IP Output
3-347
Advertisement
Table of Contents
