Table of Contents
Advertisement
•
•
•
•
•
•
•
•
•
•
3.10.5.9
Configuring the IP Input Option Card
3.10.5.9.1
IP Interface
Figure 3.49 IP Interface Parameters
•
•
•
•
•
EN/LZT 790 0005 R7A
FIFO overflow count – Displays the number of times the FIFO in the IP Input
card has overflowed.
FEC Latency – Time in milliseconds of expected video delay caused by FEC
processing.
Current Port (status) – Current active physical port.
Software version – Displays the software version used on the IP Input Card.
Firmware sw version – Displays the firmware version used on the IP Input
Card
CPLD sw version – Displays the CPLD version used on the IP Input Card.
Network Utilization – Network utilization level in %.
Rx Up Time – Time in seconds since network port is up and running.
Current Buffer Level – Delay in milliseconds caused by IP de-jittering and FEC
latency.
Reset IP Stats – This button enables the counters displayed on this screen to
be reset to 0.
IP Address – Enables the user to input the local IP address. This is used if the
port is 'pinged'.
Subnet Mask – Enables the user to input the local Subnet Mask address.
Default Gateway – Enables the user to input the local Default Gateway
address.
VLAN Tag – Virtual LAN is a group of hosts with a common set of requirements
that communicate as if they were attached to the same wire, regardless of their
physical location. This 4 bytes IEEE 802.1Q header should contain a tag
protocol identifier (TPID) and tag control information (TCI).
VLAN Enable – Enables the user to ENABLE/DISABLE the VLAN tagging.
Using the Equipment
3-83
Advertisement
Table of Contents
