Using the Equipment
Table 3.9
Channel
VHF B05
VHF B06
VHF B07
VHF B08
VHF B09
VHF B10
VHF B11
VHF B12
The "channels found" menu item (on the Advanced menu page) is populated after a
frequency scan has found all of the channels the unit can tune to in its current
location. If the unit is tuned using either a frequency or a channel the item "channels
found" will show NO SELECTION.
Note: "Channels found" is of the highest priority when changing all 3 items (i.e.
Auto Tuning
The unit can be "auto-tuned" to find a service this uses the following controls:
•
Notes: A license key is required to enable DVB-T2 functionality.
•
•
Note: Scanning status will display Normal retuning during tuning.
3-112
System B/G VHF Channel Mapping
Start Frequency
(MHz)
174
181
188
195
202
209
216
223
XML download).
Start Searching With Modulation – This indicates which modulation mode the
tuner will begin with when retune now is selected. This can be:
-
DVB-T
-
DVB-T2
-
UNKNOWN (this will try both modulation modes)
Start Searching with Bandwidth – This indicates which bandwidth type the
tuner will being with when retune now is selected. This can be:
-
6 MHz
-
7 MHz
-
8 MHz
-
UNKNOWN (this will try both modulation modes)
Retune Now – This starts the process of searching for a channel.
Center Frequency
(MHz)
177.5
184.5
191.5
198.5
205.5
212.5
219.5
226.5
End Frequency
(MHz)
181
188
195
202
209
216
223
230
EN/LZT 790 0005 R7A