Table of Contents
Advertisement
Using the Equipment
3.11.2.7
Web Browser Setup
3.11.2.7.1
Inserting the CAM
The PCMCIA slot for the CAM is located on the front left of the RX8200 and for the
RX8300 it is located on the rear right. The CAM must be inserted until there is no
more travel (do not force the card), normally the stops to the card guides on the
CAM will be flush with the front / rear panel.
The CAM can now be checked for presence. To do this, navigate to the CA tab on
the web page. Within the Common Interface area of this tab, the CI Module Status
should say PRESENT and the CI Module Name should state the name of the CAM
or CA vendor as shown in the example Figure 3.66. If this information is not seen,
make sure the CAM is fully inserted.
If no information is seen after this, please contact the Ericsson helpdesk for further
support.
Figure 3.66 CAM Insertion
3.11.2.7.2
Selecting Descramble Components
The scrambled services can be selected using the Service plus functionality. The
Service plus tab provides a single interface for all multi-service decryption and
decode functionality.
3-142
EN/LZT 790 0005 R7A
Advertisement
Table of Contents
