Check The Oil Level In The Drive Hubs; Check And Adjust The Engine Rpm - Deutz Models - Genie S-40 Service Manual

January 2005
REV A
B-8
Check the Oil Level
in the Drive Hubs
Failure to maintain proper drive hub oil levels may
cause the machine to perform poorly and continued
use may cause component damage.
1 Drive the machine to rotate the hub until the
plugs are located one on top and the other at
90 degrees.
a drive hub plugs
2 Remove the plug located at 90 degrees and
check the oil level.
Result: The oil level should be even with the
bottom of the side plug hole.
3 If necessary, remove the top plug and add oil
until the oil level is even with the bottom of the
side plug hole. Refer to Section 2,
Specifications .
4 Apply pipe thread sealant to the plug(s), and
then install the plug(s) in the drive hub.
5 Repeat this procedure for each drive hub.
Part No. 102521
Section 3 • Scheduled Maintenance Procedures
B-9
Check and Adjust the
Engine RPM - Deutz Models
Maintaining the engine rpm at the proper setting for
both low and high idle is essential to good engine
performance and service life. The machine will not
operate properly if the rpm is incorrect and
continued use may cause component damage.
1 Remove the engine tray retaining fasteners
a
located under the engine tray. Swing the engine
tray out and away from the machine and secure
it from moving.
2 Connect an rpm gauge to the engine, and then
start the engine from the ground controls.
Result: Deutz F3L 1011F Engine
Skip to step 5 if the low idle rpm is correct.
Genie S-40 and Genie S-45
CHECKLIST B PROCEDURES
This procedure will require two
people.
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
Low idle should be 1500 rpm.
Deutz F4L 1011F Engine
Low idle should be 1200 rpm.
Deutz F3L 2011 Engine
Low idle should be 1500 rpm.
3 - 23