Inspect The Operator's Manual; Inspect The Decals And Placards; Inspect For Damage, Loose Or Missing Parts - Genie Superlift SL-5 Parts & Service Manual

Section 4 - Scheduled Maintenance Procedures
Table A Procedures
A-1

Inspect the Operator's Manual

Maintaining the operator's manual in good condition
is essential to safe machine operation. The
operator's manual is included with each machine
and should be stored in the box provided on the
mast. An illegible or missing manual will not provide
safety and operational information necessary for a
safe operating condition.
1 Check to make sure the operator's manual is
present and complete in the storage container
on the mast.
2 Examine the pages of the manual to be sure
that they are legible and in good condition.
3 Always return the manual to the storage
container after use.
Contact your authorized Genie
distributor or Genie Industries if a
replacement manual is needed.
A-2

Inspect the Decals and Placards

Maintaining all of the safety and instructional
decals and placards in good condition is essential
for safe machine operation. Decals alert operators
and personnel to the many possible hazards
associated with using this machine. They also
provide users with operation and maintenance
information. An illegible decal will fail to alert
personnel of a procedure or hazard and could result
in unsafe operating conditions.
1 Refer to the decals section in the operator's
manual and use the decal list and illustration to
determine that all decals and placards are in
place.
4 - 2
Parts and Service Manual - First Edition
2 Inspect all decals for legibility and damage.
Replace any damaged or illegible decal
immediately.
A-3
Inspect for Damage , Loose or
Missing Parts
Daily machine condition inspections are essential
to safe machine operation and good machine
performance. Failure to locate and repair damage,
and discover loose or missing parts may result in
an unsafe operating condition.
1 Inspect the entire machine for damage and
improperly installed or missing parts including:
· cable anchor
· cable and pulleys
· mast columns
· exterior plastic shims for safety brake
· nuts, bolts and other fasteners
· load handling attachment
· winch and related components
· legs and casters
· stabilizers, latch plates and casters
· loading wheels and snap pin
· dents or damage to machine
· cracks in welds or structural components
· corrosion to painted surfaces
· corrosion or oxidation to all other surfaces
Genie Superlift
Contact your authorized Genie
distributor or Genie Industries if
replacement decals are needed.
Part No. 32283