Inspect The Operator's Manual; Inspect The Decals And Placards; Inspect For Damage, Loose Or Missing Parts - Genie SUPERLIFT Contractor SLC-6 Parts & Service Manual

Section 4 - Scheduled Maintenance Procedures
Table A Procedures
A-1
Inspect the Operator's Manual
Maintaining the operator's manual in good
condition is essential to safe machine operation.
The operator's manual is included with each
machine and should be stored in the box provided
on the mast. An illegible or missing manual will not
provide safety and operational information
necessary for a safe operating condition.
1 Check to make sure the operator's manual is
present and complete in the storage container
on the mast.
2 Examine the pages of the manual to be sure
that they are legible and in good condition.
3 Always return the manual to the storage
container after use.
• H';t
H"l':JIII!
Contact your authorized Genie
IIIII i l J ll'j • d1stnbutor or Geme lndustnes 1f a
replacement manual is needed.
A-2
Inspect the Decals and Placards
Maintaining all of the safety and instructional
decals and placards in good condition is essential
for safe machine operation. Decals alert operators
and personnel to the many possible hazards
associated with using this machine. They also
provide users with operation and maintenance
information. An illegible decal will fail to alert
personnel of a procedure or hazard and could
result in unsafe operating conditions.
1 Refer to the decals section in the operator's
manual and use the decal list and illustration to
determine that all decals and placards are in
place.
Parts and Service Manual - First Edition
2 Inspect all decals for legibility and damage.
Replace any damaged or illegible decal
immediately.
•
~
r;j'i
pI
Contact your authorized Genie
c ! I J
distributor or Genie Industries if
replacement decals are needed.
A-3
Inspect for Damage , Loose or
Missing Parts
Daily machine condition inspections are essential
to safe machine operation and good machine
performance. Failure to locate and repair damage,
and discover loose or missing parts may result in
an unsafe operating condition.
1
Inspect the entire machine for damage and
improperly installed or missing parts including:
llll!lnf '\ i fJ
a
Refer to Section Seven, Service
lllll!.~.t.. 1 .i.l
UD
Parts, for component locations.
cable anchor
cable and pulleys
mast columns
nuts, bolts and other fasteners
load handling attachment
winch and related components
legs and casters
stabilizers, latch plates and casters
loading wheels and pull pin
manual storage container
dents or damage to machine
cracks in welds or structural components
corrosion to painted surfaces
corrosion or oxidation to all other surfaces
4-2 Genie Superlift Contractor Part No. 33953