Check The Free-Wheel Configuration - Genie S-40 Service Manual

October 2013
9 Check to ensure that each lower bearing
mounting bolt under the drive chassis is
torqued in sequence to specifications. Refer to
Section 2, Specifications.
10
13
6
18
3
11
20
8
16
Bolt torque sequence
10 Swing the engine back to its original position
and install the engine pivot plate retaining
fasteners.
Crushing hazard. Failure to install
the fasteners into the engine tray
to secure it from moving could
result in death or serious injury.
Part No. 102521
1
15
7
19
12
4
17
5
14
9
2
S-40 • S-45
Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
D-3
Check the Free-wheel
Configuration
Genie specifications requires that this procedure
be performed every 1000 hours or annually,
whichever comes first.
Proper use of the free-wheel configuration is
essential to safe machine operation. The
free-wheel configuration is used primarily for
towing. A machine configured to free-wheel without
operator knowledge may cause death or serious
injury and property damage.
Collision hazard. Select a work
site that is firm and level.
Component damage hazard. If the
machine must be towed, do not
exceed 2 mph / 3.2 km/h.
Non-steer Wheels: All Models
1 Chock the steer wheels to prevent the machine
from rolling.
2 Center a lifting jack of sufficient capacity
(20,000 lbs / 10,000 kg) under the drive chassis
between the non-steer tires.
3 Lift the wheels off the ground and then place
jack stands under the drive chassis for support.
4 Disengage the drive hubs by turning over the
drive hub disconnect caps on each
non-steer wheel hub.
disengaged position
engaged position
3 - 43