Inspect The Track Components, Trax Option - Genie S-40 Service Manual

October 2013
Perkins models
Required maintenance procedures and additional
engine information are available in the
Perkins 404-22 Operation Manual
(Perkins part number TPD 1443S).
Perkins 404-22 Operation Manual
Genie part number
Ford models
Required maintenance procedures and additional
engine information are available in the
Ford LRG-425 EFI Operator Handbook
(Ford part number FPP 194-302) or the
Ford DSG-423 EFI Operator Handbook
(EDI part number 1060020) or the
Ford MSG-425 EFI Operator Handbook
(Ford part number 1020010).
Ford LRG 425 EFI Operation Manual
Genie part number
Ford DSG 423 EFI Operator Handbook
Genie part number
Ford MSG-425 EFI Operator Handbook
Genie part number
To access the engine:
Remove the engine tray retaining fasteners
located under the engine tray. Loosen the pivot
fastener located at the platform end of the
engine tray. Swing the engine tray out and
away from the machine and secure it from
moving.
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
Part No. 102521
Section 3 • Scheduled Maintenance Procedures
A-5
Inspect the Track Components,
TRAX option
Note: Genie specifications require that this
94890
procedure be performed daily or every 8 hours,
whichever comes first.
Maintaining tracks and track assembly components
is essential to safe operation and good
performance. A track assembly failure could result
in a machine tip-over. Component damage may
also result if problems are not discovered and
repaired in a timely fashion.
1 Thoroughly clean the track assembly of any dirt,
rocks, clay, etc.
2 Inspect the following areas for damaged,
cracked, loose or missing parts and fasteners:
• Track
84792
• Idler wheels
• Drive sprocket and hub
119488
• Bogey wheels
• Undercarriage
215322
• Kingpin and steering linkage bushings
S-40 • S-45
CHECKLIST A PROCEDURES
3 - 9