Dhcpv6 Relay - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Interface Name
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Edit button to re-configure the specific entry.

DHCPv6 Relay

DHCPv6 Relay Global Settings
This window is used to configure the DHCPv6 relay function on the Switch.
To view this window, click Network Application > DHCP > DHCPv6 Relay > DHCPv6 Relay Global Settings as
shown below:
The fields that can be configured are described below:
Parameter
DHCPv6 Relay State
DHCPv6 Relay Hops
Count (1-32)
Click the Apply button to accept the changes made for each individual section.
DHCPv6 Relay Settings
This window is used to configure the DHCPv6 relay state of one or all of the specified interfaces, and add or
display a destination IPv6 address to or from the switch's DHCPv6 relay table.
To view this window, click Network Application > DHCP > DHCPv6 Relay > DHCPv6 Relay Settings as shown
below:
Figure 10-28 DHCPv6 Server Interface Settings window
Description
Enter the name of the IP interface.
Figure 10-29 DHCPv6 Relay Global Settings window
Description
Click the radio buttons to enable or disable the DHCPv6 relay function.
Enter the number of relay agents that have to be relayed in this message. The default
value is 4.
521