Adding An Ethernet Egress Acl Profile - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

Adding an Ethernet Egress ACL Profile

The window shown below is the Add Egress ACL Profile window for Ethernet. To use specific filtering masks in this
egress ACL profile, click the packet filtering mask field to highlight it red. This will add more filed to the mask.
After clicking the Add Egress ACL button, the following page will appear:
The fields that can be configured are described below:
Parameter
Profile ID (1-4)
Profile Name
Select ACL Type
Source MAC Mask
Destination MAC
Mask
802.1Q VLAN
802.1p
Figure 8-49 Add Egress ACL Profile window (Ethernet ACL)
Description
Enter a unique identifier number for this profile set. This value can be set from 1 to 4.
Enter a profile name for the profile created.
Select profile based on Ethernet (MAC Address), IPv4 address, or IPv6 address. This
will change the window according to the requirements for the type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each packet
header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each frame's
header.
Select IPv6 ACL to instruct the Switch to examine the IPv6 address in each frame's
header.
Enter a MAC address mask for the source MAC address.
Enter a MAC address mask for the destination MAC address.
Selecting this option instructs the Switch to examine the 802.1Q VLAN identifier of
each packet header and use this as the full or partial criterion for forwarding.
Selecting this option instructs the Switch to examine the 802.1p priority value of each
packet header and use this as the, or part of the criterion for forwarding.
402