Ipv4 Route Table; Ipv6 Static/Default Route Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

IPv4 Route Table

The IP routing table stores all the external routes information of the Switch. This window displays all the external
route information on the Switch.
To view the following window, click L3 Features > IPv4 Route Table, as shown below:
The fields that can be configured are described below:
Parameter
Network Address
IP Address
RIP
OSPF
Hardware
BGP
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

IPv6 Static/Default Route Settings

A static entry of an IPv6 address can be entered into the Switch's routing table for IPv6 formatted addresses.
Figure 6-3 IPv4 Route Table window (EI Mode Only)
Figure 6-4 IPv4 Route Table window (SI Mode Only)
Description
Enter the destination network address of the route want to be displayed.
Enter the destination IP address of the route want to be displayed. The longest prefix
matched route will be displayed.
Tick the check box to display only RIP routes.
Tick the check box to display only OSPF routes.
Tick the check box to display only the routes that have been written into the chip.
Tick the check box to display only BGP routes. (EI Mode Only)
207