D-Link xStack DGS-3620 Series Reference Manual page 286

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Parameter
Group Address
Click the Find button to find the entry, based on the information entered.
PIM SSM Settings
This window is used to enable the SSM (Source-Specific Multicast) service model in PIM-SM on the Switch. The
PIM-SSM function will take active only when SSM service model and PIM-SM state both enabled.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM
SSM Settings, as shown below:
The fields that can be configured are described below:
Parameter
SSM Service Model
State
SSM Group Address
SSM Group Mask
Click the Apply button to accept the changes made.
PIM for IPv6 (EI Mode Only)
PIM for IPv6 Global Settings
This window is used to set the PIM for IPv6 multicast protocol state and some related parameters in the protocol on
some interfaces.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for
IPv6 Global Settings, as shown below:
Description
Enter the group address that will be displayed here.
Figure 6-115 PIM SSM Settings window
Description
Click the radio buttons to enable or disable the SSM service model on the Switch.
Enter the group address range for the SSM service in IPv4. Tick the Default check box
to indicate that the group address range is 232.0.0.0/8.
Enter the netmask of the SSM group.
285