D-Link xStack DGS-3620 Series Reference Manual page 543

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
State
MAC Address
Period
PDU Priority
Type
Figure 11-10 CFM LM Settings window
Description
Select to enable or disable the CFM LM setting. This specifies the administrative state
of frame loss measurement function on the MEP.
Enabled - Specifies that the frame loss measurement function will be enabled.
Disabled - Specifies that the frame loss measurement function will be disabled.
Enter the MAC address.
Select the period. This specifies the transmission period of LMM message.
100ms - Specifies that the transmission period will be 100ms.
1sec - Specifies that the transmission period will be 1sec.
10sec - Specifies that the transmission period will be 10sec.
Select the PDU priority. This specifies the 802.1p priority which is set in the LMM
message transmitted by the MEP.
0 to 7 - Select the 802.1p priority which is set in the LMM message transmitted by the
MEP. This value must be between 1 and 7.
Select the type that will be cleared.
Results - Specifies to clear the stored frame loss measurement results. If none of them
is specified, both of them are cleared.
Statistics - Specifies to clear the stored statistics of ETH-LM frames (LMM, LMR). If
542