Igmp Snooping Rate Limit Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
After clicking the Modify Router Port
The fields that can be configured are described below:
Parameter
Unit
Static Router Port
Forbidden Router Port
Dynamic Router Port
Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.

IGMP Snooping Rate Limit Settings

On this page the user can configure the IGMP snooping rate limit parameters.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping
Rate Limit Settings, as shown below:
operation. The General Query won't be sent on the same domain of link-layer
topology changes. Selecting Process specifies that IGMP snooping will process
link-layer topology changes caused by Spanning Tree operation. The General
Query will be sent on the same domain of link-layer topology changes.
link, the following page will appear:
Figure 5-64 IGMP Snooping Router Port Settings window
Description
Select the unit you want to configure.
This section is used to designate a range of ports as being connected to multicast-
enabled routers. This will ensure that all packets with such a router as its destination
will reach the multicast-enabled router regardless of the protocol.
This section is used to designate a range of ports as being not connected to
multicast-enabled routers. This ensures that the forbidden router port will not
propagate routing packets out.
Displays router ports that have been dynamically configured.
149