D-Link xStack DGS-3620 Series Reference Manual page 211

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Policy Route Name
Click the Add button to add a new entry based on the information entered.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Click the Edit button to see the following window.
The fields that can be configured are described below:
Parameter
Profile ID (1-6)
Access ID (1-256)
Next Hop IPv4 Address
State
Route Preference
Click the <<Back button to return to the previous window.
Click the Apply button to accept the changes made.
Figure 6-9 Policy Route Settings window
Description
Enter the policy route name. The maximum length is 32 characters.
Figure 6-10 Policy Route Settings - Edit window
Description
Enter the ACL profile ID.
Enter the ACL access ID.
Enter the next hop IP address.
Use the drop-down menu to enable or disable this rule.
Select the route preference used here. Options to choose from are Default and
PBR.
Default - Specifies that the policy based route has lower priority than the route in
the routing table.
PBR - Specifies that the policy based route has higher priority than the route in the
routing table.
210