D-Link xStack DGS-3620 Series Reference Manual page 362

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Unit
From Port ~ To Port
Willing
State
CoS List (0-7)
Type
Click the Apply button to accept the changes made.
Figure 7-12 PFC Port Settings window
Description
Select the switch unit number, from the stack, that will be configured here.
Select the range of 10G ports that will be configured or cleared here.
Select whether to enable or disable the PFC willing feature here. This feature
indicates that the local port is willing to accept the PFC configuration from a remote
system. Data Center Bridging eXchange Protocol (DCBX) is used by DCB devices
to exchange configuration information with directly connected peers. The protocol
may also be used for misconfiguration detection and for configuration of the peer.
The willing mode indicates that the local port has been administratively configured to
accept configuration from the remote device.
Select to enable or disable the PFC state on the ports specified here.
Enter the CoS list value that will be used here. When selecting the All option, this
field will be greyed out and all CoS values will be applied.
Select the type of PFC counter information to clear here. Options to choose from are
RX, TX, and Both. RX specifies to clear the received PFC frames counters. TX
specifies to clear the transmitted PFC frames counters. The Both option specifies to
clear both the received and transmitted PFC frames counters.
361