Mac-Based Access Control Port Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Click the Delete button to remove the entry based on the information entered.

MAC-based Access Control Port Settings

On this page, users can view and configure the MAC-based Access Control port settings on the Switch.
To view this window, click Security > MAC-based Access Control (MAC) > MAC-based Access Control Port
Settings as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
State
Aging Time (1-1440)
Block Time (0-300)
Max User (1-4000)
Click the Apply button to accept the changes made.
Figure 9-35 MAC-based Access Control Port Settings window
Description
Select the switch unit to configure.
Use the drop-down menus to select a range of ports to be configured for MAC-based
access control.
Use this drop-down menu to enable or disable MAC-based access control on the port
or range of ports selected in the Port Settings section of this window.
Enter a value between 1 and 1440 minutes. The default is 1440. To set this value to
have no aging time, select the Infinite option.
Enter a value between 0 and 300 seconds. The default is 300.
Enter the maximum user used for this configuration. When No Limit is selected, there
will be no user limit applied to this rule.
446