D-Link xStack DGS-3620 Series Reference Manual page 314

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Hold Time (0-65535)
AS Origination Interval
(1-600)
Connect Retry Interval
(1-65535)
Click the Apply button to accept the changes made.
BGP Neighbor Map Settings
This window is used to configure BGP neighbor map settings.
To view the following window, click L3 Features > BGP > BGP Neighbor > BGP Neighbor Map Settings, as
shown below:
The fields that can be configured are described below:
Parameter
Neighbor Address
Peer Group Name
Address Family
Unsuppress Map
Action
Unsuppress Map
Name
Route Map Type
The system will declare a peer as dead if not receiving a keepalive message until the
hold time. If two routers, that built a BGP connection, have different hold times, the
smaller hold time will be used. The valid value is from 0 to 65535. If the holdtime is
zero, then the holdtime will never expire. It is recommended that the holdtime value is
three times that of the keepalive timer. Tick the Default check box to clear the
specification of the neighbor specific hold time setting.
Enter the minimum interval between the sending AS origination routing updates. The
valid value is from 1 to 600. The default setting is 15 seconds.
Enter the minimum interval BGP sends TCP connect requests to the peer after a
TCP connection fail happens. The valid value is from 1 to 65535. Tick the Default
check box to use the connect retry interval default value.
Figure 6-155 BGP Neighbor Map Settings window
Description
Click the radio button and use the drop-down menu to select the address of the BGP
speaking neighbor.
Click the radio button and use the drop-down menu to select the name of the BGP
peer group.
Select the address family that will be configured here. Options to choose from are
IPv4 Unicast and IPv6 Unicast.
Use the drop-down menu to select Add or Delete.
Enter the name of a route map used to selectively advertise routes previously
suppressed by the aggregate address command.
Use the drop-down menu to select In or Out. In specifies the incoming routes from
the neighbor and Out specifies the outgoing routes sent to the peer.
313